Packet tracer activity 2.2.4.9 serial#

There is no IP address configured on the GigabitEthernet 0/0 interface.Дў) What is the MAC address of the GigabitEthernet 0/0 interface?ДЈ) What is the bandwidth (BW) of the GigabitEthernet 0/0 interface?ДЎ000000 kbits Step 2: Display a summary list of the interfaces on R1. Enter the command to display the statistics for the GigabitEthernet 0/0 interface and answer the following questions:.

Packet tracer activity 2.2.4.9 serial#

Enter the command to display the statistics for the Serial 0/0/0 interface on R1 and answer the following questions:ДЎ) What is the IP address configured on R1 ?Дў) What is the bandwidth on the Serial 0/0/0 interface?.

Which command displays the information about the Serial 0/0/0 interface only?.

Which command displays the statistics for all interfaces configured on a router?.

Note : Click a device and then click the CLI tab to access the command line directly. Part 1: Display Router Information Step 1: Display interface information on R1.

This is done so that this activity is ready to provide complete output from show commands when the student configures and activates the Ethernet interfaces. In addition, routing is configured using OSPF. Some of the configurations are not covered in this course but they are provided to assist you in using verification commands.ДЄnswers Note : The serial interfaces are already configured and active. Note : The routers in this activity are partially configured. Finally, you will use commands to verify and test your configurations. You will then use the Addressing Table to configure router Ethernet interfaces.

In this activity, you will use various show commands to display the current state of the router. Part 3: Verify the Configuration Background